< . :
: The ceramic panel in the ceramic roller coating is smooth, wear-resistant, strong impact resistant, easy to install, and the ceramic surface is not easy to fall off. Ceramic size:
3, Ceramic
3 content: 3
3 or more, Mohs hardness:
3 or more, Specific gravity:
3 or more, Compressive strength is not Less than 3
3.
.
. :
: Ceramic dry abrasion test is carried out before fluidization. The standards are as follows: grinding speed
3 times
3 minutes, test load:
3 pounds, silica sand particle size:
Abrasion amount:
less than 3.
.
. :
: Requirements for the steel plate on the surface of the drum installed with ceramic drum rubber: the surface should be sandblasted to
level 3 and degreased. The surface of the non-coated parts is also sandblasted. After reaching level 3, anti-rust primer is sprayed.
.
. :
: The rubber sheet used in the ceramic roller lagging is required to be: thickness
hardness
tensile strength
elongation 3
Steel plate
3 Rubber peel strength
Ceramics
3 Rubber peel strength
3.
. Treatment agent for surface treatment.
Cold vulcanization lagging can be wear-resistant, heat-resistant, flame-retardant, antistatic, and anti-adhesion. It has stable performance and is not prone to aging. The bonding efficiency and speed are 2 times that of hot vulcanization lagging.
3.:
Roller lagging ceramic rubber plate